Policy-Based Tunnel Selection (PBTS) 186, 187, 286
figure, implementation 186
functions 187
how to configure 286
how to define 186
pools 173
prefixes 7
prerequisites 6, 27, 34, 39, 112, 165, 180, 216, 371
general 371
Prestandard DS-TE mode 172
protection and restoration 179
protection and restoration, GMPLS 179, 180
end-to-end recovery 180
requirements 180
shared mesh 179
span protection 179
protocol-based CLI 171
R
RDM (russian doll model) and MAM (maximum allocation
model) 172
RDM and MAM 173
RDM bandwidth constraint model 173
RDM, how to configure 123
recovery time 116
refresh interval, how to change 147
refresh reduction 112
Refresh Reduction and Reliable Messaging Configuration 147
Example command 147
remote label binding 7
requirements 180
Resource Reservation Protocol (RSVP) 117
Management Information Base (MIB) 117
restart time 116
restart time, how to change 149
restrictions 193
router IDs, how to configure 242
routing protocols 7
RSVP 111, 112, 113, 114, 116, 117, 122, 123, 125, 126, 127, 129
ACL-based prefix filtering 117
compliance 112
configuration 112, 123, 125, 126, 127, 129
description 111
diffserv-TE bandwidth, how to confirm 123
extensions 112
fault handling 114
graceful restart 114
head node 113
hello messages 116
high availability 113
how to configure 123
RSVP (continued)
implementing 122
message rate limiting 112
node failure 116
overview 112
prerequisites 112
recovery time 116
refresh reduction 112
restart time 116
support for graceful restart 112
tail node 113
topology 129
with O-UNI LSP, configuring 112
RSVP Authentication by Using All the Modes 152
Example command 152
RSVP Authentication for an Interface 151
Example command 151
RSVP Authentication Global Configuration Mode 150
Example command 150
RSVP messages 116
RSVP Neighbor Authentication 151
Example command 151
RSVP nodes 113
head node 113
tail node 113
Russian Doll Model (RDM) and Maximum Allocation Model
(MAM) 172
RVSP node failure 116
S
session parameters 11
session protection 16
session protection, LDP 16
Setting DSCP for RSVP Packets 149
Example command 149
shared mesh 179
soft-preemption 203
span protection 179
SRLG (shared-risk link group) 294
configuring 294
summary refresh message size, how to change 148
support 178
support for 7
support for graceful restart 112
synchronizing with LDP 17
T
tail node 113
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
IN-6
Index