The following information about the traffic disruption
is displayed:
•
Type of traffic disruption, e.g. accident
•
Severity of the traffic disruption: slow, heavily
congested or stopped traffic
•
Length of the traffic disruption
•
Duration of delay
The system will also give the option of Avoid to recal-
culate the route to avoid the delay.
1.
Select Avoid. An alternative route is calculated.
2.
Select the new route on the map on by selecting
the button showing the change in distance or
time.
3.
The route on the map and the bar update. Let’s
Go··· appears.
Standard Cruise Control
WARNING
Do not use the cruise control system when driv-
ing conditions do not permit maintaining a con-
stant speed, such as in heavy traffic or on roads
that are winding, icy, snow-covered, slippery, or
roads with a loose driving surface. Failure to fol-
low this precaution could cause a collision or
loss of vehicle control, possibly resulting in per-
sonal injury or property damage.
NOTICE
When the cruise control is engaged, do not at-
tempt to shift gears without using the clutch
pedal. Failure to follow this precaution will result
in a temporarily uncontrolled increase in engine
speed. Transmission damage and gear stripping
could result.
NOTE: If the vehicle is equipped with a Detroit
automated transmission, setting the cruise con-
trol with the engine brake on will activate De-
scent Control Mode. Moving the transmission
shift lever to the top position will resume the set
cruise speed. Moving the lever down to engage
the engine brake after the cruise control has
been set will activate Deceleration Mode. See
"Descent Control and Deceleration Modes, De-
troit
™
Automated Transmissions" in this chapter.
In the ICUC, standard cruise control is operated by
three switches mounted in the right-hand switch pod
of the steering wheel. See Fig. 7.16.
In the ICC5, standard cruise control is operated by
three buttons mounted in the left-hand pod of the
steering wheel. See
Fig. 7.17.
•
Cruise Decelerate/SET Button—Press to set
the cruise speed while the vehicle is traveling
at the desired speed. Press and hold to de-
crease the set cruise speed by 5 mph incre-
ments (Detroit Diesel engines only). Single
press decreases cruise speed by 1 mph. When
cruise control has been set, the driver display
static menu in the ICUC shows relevant cruise
control icons and the set speed. See
Fig. 7.18.
The speed memory will be retained until the
ignition is turned off.
•
CNCL Button —Press to pause the cruise con-
trol, while retaining the speed setting in
memory. The cruise control can also be disen-
gaged, while retaining the speed memory, by
depressing the brake or clutch pedals.
•
Cruise Accelerate/RES Button—Press to re-
sume the set speed. Press and hold to in-
crease the set cruise speed by 5 mph incre-
ments (Detroit Diesel engines only). Single
press increases cruise speed by 1 mph. If no
f611352e08/14/2019
8
7
1
2
3
4
6
5
1. Cruise Accelerate/Resume
2. Quick Access System Settings
3. Cruise Decelerate/Set
4. Phone Hang-Up/Reject
5. Marker Interrupt
**
6. Phone Pick-Up
7. Headlamp Interrupt
**
8. Cancel Cruise Control
**
Not available in all markets
Fig. 7.16, Steering-Wheel-Mounted Right-Hand Switch
Pod-ICUC
Driver Assistance Features
7.15
To Next Page
Loading...