Datalogic Magellan 800i

Enter/Exit Programming Mode Code 93
104 Magellan™ 800i Scanner
Code 93 Length 1, Length 2 Programming Instructions
See page 136for detailed instructions on setting this feature.
NOTE
0685(CR)
DEFAULT SETTING FOR THIS FEATURE: 01
Set Length 1
Set Length 2
0686(CR)
DEFAULT SETTING FOR THIS FEATURE: 50
For Code 93 bar codes, only the data
characters are included in the length
calculations.
Code 93 Stitching
Enables/disables stitching for Code 93 bar codes. When parts of a Code 93
label are presented to the scanner with this feature enabled, the bar code parts
will be assembled by the scanner’s software, and the data will be decoded if all
bar code proofing requirements are met.
06AE00(CR)
Disable Code 93 Stitching
Enable Code 93 Stitching
DEFAULT
06AE01(CR)