Datalogic Magellan 800i

Enter/Exit Programming Mode MSI/Plessey
106 Magellan™ 800i Scanner
Check Digit Verification
This feature specifies whether one or two check digits are to be calculated and
verified. When disabled, any check characters in a label are treated as data
characters.
021600(CR)
Disable Check Digit Verification
Enable Check Digit Verification
DEFAULT
021601(CR)
Check Digit Transmit
When this option is enabled, the scanner will transmit one-digit or two-digit
check digits, depending upon the setting for check digit verification. Applies
when the feature Check Digit Verification on page 5-106 is enabled.
00BE00(CR)
Disable Check Digit Transmission
Enable Check Digit Transmission
DEFAULT
00BE01(CR)
Number of Check Characters
Specifies number of MSI/Plessey check characters to be calculated and verified.
Check characters are always modulus 10.
021700(CR)
1 Check Character
DEFAULT
2 Check Characters
021701(CR)