Datalogic Magellan 800i

Enter/Exit Programming Mode Image Capture
22 Magellan™ 800i Scanner
Image Compression
Specifies the starting image compression factor for JPEG images. A higher num-
ber specifies a higher quality image with less compression than a relative lower
n
umber for the same image.
A value of 100 means minimal compression. A value of 1 means maximum
co
mpression at a loss of quality. Follow these steps to program this feature:
1. Scan the START bar code.
2. Scan the Set Image Compression bar code.
3. Turn to Alphanumeric Pad and scan the two digits (zero-padded)
repre-
senting the desired compressi
on. The configurable range is 01-0x64 by
increments of 01.
4. Scan the END bar code.
03ED1E(CR)
Image Compression = 30
(higher compression — lower quality)
Image Compression = 50
(
medium compression — medium quality)
03ED32(CR)
03ED64(CR)
Image Compression = 100
(minimal compression — higher quality)
DEFAULT