Datalogic Magellan 800i

Enter/Exit Programming Mode
Product Reference Guide 15
Good Read: When to Indicate
This feature specifies when the scanner will provide indication (beep and/or
flash its green LED) upon successfully reading a bar code. Choices are:
• Good Read = Indicate after decode
• Good Read = Indicate after transmit
• Good Read = Indicate after CTS
goes inactive, then activ
NOTE
This option (Indicate after CTS goes inactive,
t
hen active), which uses CTS, is only valid for
RS-232 interfaces. If set to this mode in other
interfaces, “Indicate after decode” mode will
be assumed. This setting will only work if CTS
Scan control is enabled.
e
• Good Read = Beep after each output structure proofed
NOTE
After Decode
DEFAULT
009900(CR)
009901(CR)
After Transmit
After CTS goes inactive, then active
009902(CR)
009903(CR)
Beep after each output structure proofed
When beeping after each output structure
decoded, if multiple output structures, there
is a delay after the beep has finished. The
delay is equal to the good beep length or can
be set by a ULE script.