Datalogic Magellan 800i Product Reference Guide

Error Codes
Product Reference Guide 5
Error Codes
Upon startup, if the scanner flashes its indicator LED or sounds an unexpected
series of beep tones (other than normal power-up indications), this means the
scanner has not passed its automatic Selftest and has entered FRU (Field
Replaceable Unit) isolation mode. If the scanner is reset or the trigger is pulled,
the sequence will be repeated. The following table describes the LED flashes/
beep codes associated with an error found.
NUMBER OF
LED
FLASHES/
BEEPS
ERROR CORRECTIVE ACTION
1
Configuration
Contact Helpdesk for assistance
2
Interface
6
System Controller
12
Imager System
13
Software ID
Failure

Datalogic Magellan 800i Specifications

General

Scanner type	2D
Yaw reading angle	-60 - 60 °
Decoding standards	GS1 DataBar, Aztec Code, Data Matrix, MaxiCode, QR Code, GS1 DataBar Expanded Stacked, GS1 DataBar Stacked, GS1 DataBar Stacked Omnidirectional, MicroPDF417, PDF417
Tilt reading angle	0 - 360 °
Optical sensor resolution	752 pixels
Light levels (direct sunlight)	0 - 86000 lx
Bluetooth	No
Cable length	2 m
Standard interfaces	USB
Input voltage	5 V
Power consumption	350 mA
Dimensions (WxDxH)	76 x 109 x 151 mm
Certification	China RoHS EU RoHS
Product color	White
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	5 - 95 %

Weight and Dimensions

Weight	306.2 g