Datalogic Magellan 800i

Enter/Exit Programming Mode
Product Reference Guide 55
Label ID — cont.
NOTE
For the 2D symbologies on this page, the Label ID is 4 bytes.
The first 3 bytes are characters for the label ID. A 00 (hex) value
in the first 3 bytes indicates the end of the label ID characters.
The 4th byte is a control byte.
The use of the control byte is as follows:
bit 0-if set to 1, the AIM Id is appended for that label type
DEFAULT SETTING FOR THIS FEATURE: mP (6D500000
hex)
Set Micro PDF 417 Label ID Character(s)
Set QR Code Label ID Character(s)
DEFAULT SETTING FOR THIS FEATURE: QR (51520000
hex)
DEFAULT SETTING FOR THIS FEATURE: $Q (2451 hex)
Set Micro QR Code Label ID Character(s)
Set Maxicode Label ID Character(s)
DEFAULT SETTING FOR THIS FEATURE: MC (4D430000
hex)
DEFAULT SETTING FOR THIS FEATURE: Az (417A0000
hex)
Set Aztec Label ID Character(s)
Set GS1 DataBar Omnidirectional 2D Composite
Label ID Character(s)
DEFAULT SETTING FOR THIS FEATURE: R4 (52340000
hex)
0353(CR)
03DC(CR)
0429(CR)
03D5(CR)
0435(CR)
0366(CR)