Datalogic Magellan 9400i User Manual

Enter/Exit Programming Mode General Scanner and Scale Features
134 Magellan™ 9300i / 9400i Scanners
Label Gone Timeout
Specifies the amount of time in cycles (one cycle = 25ms) that data segments
are stored by the software before being discarded if a label has not been suc
-
cessfully decoded during the current “label in volume session,” which is defined
as the time between when the label gone time is first started until the label
gone timer expires.
To set the Label Gone Timeout:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any
unused bar codes
on this and the facing page to ensure that the scanner reads
only the bar code you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Pro-
gramming Mode bar code.
NOTE
This only applies to UPC/EAN labels when segment assembly
is enabled.
Label Gone Timeout = 0.4 Seconds
Label Gone Timeout = 0.6 Seconds
Label Gone Timeout = 0.8 Seconds
Label Gone Timeout = 1.2 Seconds
Label Gone Timeout = 1.6 Seconds
DEFAULT
004C10(CR)
004C18(CR)
004C20(CR)
004C30(CR)
004C40(CR)

Datalogic Magellan 9400i Specifications

General

Standard interfaces	USB
Connectivity technology	Wired
Type	Built-in bar code reader
Sensor type	Linear
Scanner type	1D/2D
Light levels (direct sunlight)	0 - 86080 lx
Linear (1D) barcodes supported	GS1 DataBar Expanded, GS1 DataBar Omnidirectional, JAN, U.P.C.
2D (matrix & stacked) barcodes supported	Aztec Code, Data Matrix, Micro QR Code, QR Code, Small Aztec Code
Input voltage	100 - 240 V
Input frequency	50 - 60 Hz
Power source type	AC
Power consumption (standby)	11 W
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	10 - 40 °C
Operating relative humidity (H-H)	5 - 95 %
Product color	Black, Grey
Housing material	-
Sustainability certificates	RoHS

Weight and Dimensions

Depth	102 mm
Width	401 mm
Height	130 mm
Weight	- g