Datalogic Magellan 9400i User Manual

Enter/Exit Programming Mode
Product Reference Guide 191
EAS Beep Duration
Sets the duration of the EAS successful deactivation beep, specified in 10ms
increments. The beep only occurs if EAS mode is not disabled.
To set the EAS Beep Duration:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan the bar code, Set EAS Beep Duration on page 191 below. You’ll need
to cover any unused bar codes on this and the facing page to ensure that
the scanner reads only the bar code you intend to scan.
3. Scan the appropriate digits from the Keypad on page 461 in Appendix C
that represent the desired EAS Beep Duration. The selectable range is 0-
255, which is the timeout in 10-millisecond increments. Pad all single and
double digit numbers with leading zeroes to yield a three-digit entry
(000-255).
Examples:
• 000 = EAS beep disabled
• 001 = 10ms
• 005 = 50ms
• 040 = 400ms
• 250 = 2,500ms (2.5 seconds)
4. Complete the programming sequence by scanning the nter/Exit Program-
ming Mode bar code.
Set EAS Beep Duration
Default setting for this feature is:
008 - 80ms
0581(CR)
DEFAULT

Datalogic Magellan 9400i Specifications

General

Standard interfaces	USB
Connectivity technology	Wired
Type	Built-in bar code reader
Sensor type	Linear
Scanner type	1D/2D
Light levels (direct sunlight)	0 - 86080 lx
Linear (1D) barcodes supported	GS1 DataBar Expanded, GS1 DataBar Omnidirectional, JAN, U.P.C.
2D (matrix & stacked) barcodes supported	Aztec Code, Data Matrix, Micro QR Code, QR Code, Small Aztec Code
Input voltage	100 - 240 V
Input frequency	50 - 60 Hz
Power source type	AC
Power consumption (standby)	11 W
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	10 - 40 °C
Operating relative humidity (H-H)	5 - 95 %
Product color	Black, Grey
Housing material	-
Sustainability certificates	RoHS

Weight and Dimensions

Depth	102 mm
Width	401 mm
Height	130 mm
Weight	- g