Enter/Exit Programming Mode 1D Symbology Programming
360 Magellan™ 9300i / 9400i Scanners
Code 39 Stitching
Enables/disables stitching for Code 39 labels. When parts of a Code 39 bar
code are presented to the scanner with this feature enabled, the bar code parts
will be assembled by the scanner’s software, and the data will be decoded if all
bar code proofing requirements are met.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Pro-
gramming Mode bar code.
Code 39 Stitching = Disable
Code 39 Stitching = Enable