Datalogic Magellan 9400i User Manual

Enter/Exit Programming Mode EAS Features
192 Magellan™ 9300i / 9400i Scanners
EAS Retry Count
This feature sets the number of times the deactivation sequence (defined by the
feature, “EAS Deactivation Duration — Retry ”) is restarted after a failed deacti
-
vation attempt.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan the bar code, Set EAS Retry Count on page 192 below. You’ll need to
cover any unused bar codes on this and the facing page to ensure that the
scanner reads only the bar code you intend to scan.
3. Scan the appropriate digits from the Keypad on page 461 in Appendix C
that represent the desired number. The selectable range is 0-15 resets.
Pad all single and double digit numbers with leading zeroes to yield a two-
digit entry (00-15).
4. Complete the programming sequence by scanning the Enter/Exit Pro-
gramming Mode bar code.
NOTE
A setting of zero specifies no deactivation retries upon failed
deactivation attempt.
Set EAS Retry Count
Default setting for this feature is:
03 - Retry EAS Deactivation three times
0583(CR)
DEFAULT

Datalogic Magellan 9400i Specifications

General

Standard interfaces	USB
Connectivity technology	Wired
Type	Built-in bar code reader
Sensor type	Linear
Scanner type	1D/2D
Light levels (direct sunlight)	0 - 86080 lx
Linear (1D) barcodes supported	GS1 DataBar Expanded, GS1 DataBar Omnidirectional, JAN, U.P.C.
2D (matrix & stacked) barcodes supported	Aztec Code, Data Matrix, Micro QR Code, QR Code, Small Aztec Code
Input voltage	100 - 240 V
Input frequency	50 - 60 Hz
Power source type	AC
Power consumption (standby)	11 W
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	10 - 40 °C
Operating relative humidity (H-H)	5 - 95 %
Product color	Black, Grey
Housing material	-
Sustainability certificates	RoHS

Weight and Dimensions

Depth	102 mm
Width	401 mm
Height	130 mm
Weight	- g