Name: Datalogic Magellan 9400i
Brand: Datalogic
Rating: 4 (1 reviews)

To Next Page

To Previous Page

68 Magellan™ 9300i / 9400i Scanners

Flowcharts

The problem isolation flowcharts on the following pages allow you to identify

and troubleshoot problems with your system.

Figure 38. Problem Isolation: Start

START

YES

Does

the scanner

power-up

YES

Does

the scanner

pass Selftest

YES

Are the

green indicator

LEDs lit

YES

Are the

green indicator

LEDs lit

YESYES

NONO

Will the

scanner read

bar codes

reliably

YES

Have you

checked the

power

connections

Check these

potential problems:

- AC power cord

- AC/DC adaptor

- AC outlet

Power-up

Scanner power-up is signified by any or

all of the following:

- Illumination LEDs turn on

- Status indicator LEDs turn on

- Speaker sounds tone(s)

- Remote display shows message

- A single red dot is visible on the 7-

segment display

Selftest Failure

If the scanner fails its Selftest, the

following takes place:

- Speaker sounds a tone at the lowest

value for approx. 3 seconds.

- Green and Yellow LEDs flash on and

off alternately.

- 7-segment display shows a code (1 to

C) to indicate the failure.

Consult the Selftest flowchart if you're

unsure the unit has passed Selftest.

Flashing Green LED

If the green good read indicator LEDs

are flashing slowly, the scanner is most

likely in Sleep Mode. Press and release

the scanner control button or wave your

hand in front of the vertical window to

"wake-up" the scanner.

Flashing green LEDs can also mean the

scanner has been disabled by the POS

terminal. To exit this mode, cycle power

or have the terminal re-enable the

scanner.

For units using an AC/DC adapter, verify that...

1. AC power cord is connected to a functional AC outlet.

2. IEC connectors are firmly connected.

3. DC power cord is firmly connected to scanner.

If your unit is a model which receives Power Off the

Terminal (POT), verify that the I/F cable is securely

connected at both ends.

Magellan

Power

Supply

Go to Selftest

flowchart

Go to EAS

system flowchart

Go to Poor/No

Reading flowchart

YES

Does the

scale weigh

correctly

Does the

EAS Antenna

deactivate

Other Problems?

Call Tech Support

Datalogic Magellan 9400i Specifications

General

Standard interfaces	USB
Connectivity technology	Wired
Type	Built-in bar code reader
Sensor type	Linear
Scanner type	1D/2D
Light levels (direct sunlight)	0 - 86080 lx
Linear (1D) barcodes supported	GS1 DataBar Expanded, GS1 DataBar Omnidirectional, JAN, U.P.C.
2D (matrix & stacked) barcodes supported	Aztec Code, Data Matrix, Micro QR Code, QR Code, Small Aztec Code
Input voltage	100 - 240 V
Input frequency	50 - 60 Hz
Power source type	AC
Power consumption (standby)	11 W
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	10 - 40 °C
Operating relative humidity (H-H)	5 - 95 %
Product color	Black, Grey
Housing material	-
Sustainability certificates	RoHS