Enter/Exit Programming Mode 1D Symbology Programming
390 Magellan™ 9300i / 9400i Scanners
Codabar Minimum Read
This feature specifies the minimum number of consecutive Codabar decodes
before is accepted as good read.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Pro-
gramming Mode bar code.
Codabar Minimum Read = 1
Codabar Minimum Read = 2
Codabar Minimum Read = 3
Codabar Minimum Read = 4
DEFAULT