Enter/Exit Programming Mode General Scanner and Scale Features
152 Magellan™ 9300i / 9400i Scanners
Good Read When to Indicate
This feature specifies when the scanner will provide indication (beep and/or
flash its green LEDs) upon successfully reading a bar code.
• Good Read = Indicate after decode.
For scanner models having intelligent integrated EAS, label transmission (and hence the
good read beep) is completed after the EAS logic executes.
• Good Read = Indicate after transmit
• Good Read = Indicate after CTS goes inactive, then active.
This mode applies to RS-232 STD and RS-232 WN interfaces only. If set in other inter-
faces, “Indicate after decode” mode will be implemented.
• Good Read = Indicate after each output structure proofed.
When beeping after each output structure decoded, if there are multiple output struc-
tures, there is a delay after the beep has finished. This delay is equal to the Good Read
Beep Length on page 150.
To set the Good Read When to Indicate feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan the desired mode bar code from those provided below You’ll need to
cover any unused bar codes on facing pages to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Pro-
gramming Mode bar code.
Good Read When to Indicate = After Decode
Good Read When to Indicate = After Transmit
Good Read When to Indicate = After CTS goes Inactive,
Then Active
Good Read When to Indicate = After Each Output
Structure Proofed
DEFAULT
To Next Page
Loading...
Need help?
General
Weight and Dimensions
