Electrical Specifications
Product Reference Guide 9
Electrical Specifications
Before installation, always verify that the site’s electrical service meets the
scanner’s requirements. The scanner has been engineered for compatibility
with most international electrical systems operating in ranges from 100 to
240VAC at 50-60 Hz. Verify that the power source will supply “clean” electrical
power to the equipment; that is, it must be free of excess electrical noise.
Check the IEC power cord shipped with the scanning-scale. If the cord will not
plug into your AC power receptacle, the power cord shipped is not compatible
with your electrical system. Please contact your distributor immediately to
receive the necessary information and components to ensure electrical compat
-
ibility.
Power Supply
The scanner utilizes a single power supply for all models. Unique installation
and international connections are accomplished through selection of the proper
IEC power cord
VOLTAGE FREQUENCY CURRENT (RMS)
100-240VAC ±10%
50-60
Hz 0.5 Amps @ 100V
CAUTION
Safe operation of your scanner or scanning-scale requires properly grounded
electrical outlets. Be sure to have a qualified electrician certify the earth-ground
connection on circuits which will be used to power the unit.
NOTE
The scanner is powered on/off by connecting/disconnecting its power supply.