Datalogic Magellan 9400i User Manual

LED and Beeper Indicators Enter/Exit Programming Mode
Product Reference Guide 151
Good Read Beep Volume
Selects the beeper volume upon a good read beep. There are five selectable
volumes, with each volume increment adding approximately five decibels to the
previous level:
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any unused bar
codes on this and the facing page to ensure that the scanner reads only the bar
code you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming
Mode bar code.
•Low •Medium High
•Medium Low •High
•Medium
Good Read Beep Volume = Low
Good Read Beep Volume = Medium Low
Good Read Beep Volume = Medium
Good Read Beep Volume = Medium High
Good Read Beep Volume = High
001900(CR)
001901(CR)
DEFAULT
001902(CR)
001903(CR)
001904(CR)

Datalogic Magellan 9400i Specifications

General

Standard interfaces	USB
Connectivity technology	Wired
Type	Built-in bar code reader
Sensor type	Linear
Scanner type	1D/2D
Light levels (direct sunlight)	0 - 86080 lx
Linear (1D) barcodes supported	GS1 DataBar Expanded, GS1 DataBar Omnidirectional, JAN, U.P.C.
2D (matrix & stacked) barcodes supported	Aztec Code, Data Matrix, Micro QR Code, QR Code, Small Aztec Code
Input voltage	100 - 240 V
Input frequency	50 - 60 Hz
Power source type	AC
Power consumption (standby)	11 W
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	10 - 40 °C
Operating relative humidity (H-H)	5 - 95 %
Product color	Black, Grey
Housing material	-
Sustainability certificates	RoHS

Weight and Dimensions

Depth	102 mm
Width	401 mm
Height	130 mm
Weight	- g