Ergonomic Recommendations
Product Reference Guide
27
SECTION II. CHECKSTAND PREPARATION
When performing a first-time installation into a new checkstand, verify before
cutting that room will be allowed for cabling and the AC/DC Power Supply.
When making the opening, take extra care to accurately cut to the correct
dimensions. Mounting may require installation of support(s), countertop rout
-
ing, or other such devices. Depending upon checkstand design, you may wish
to install an item diverter to direct items toward the scan window. See “Counter
Cutout” below for more details concerning the location and preparation of the
opening.
Some models are designed to fit with little or no modification into openings cut
for previously installed scanners such as other Magellan
™
scanners, or NCR
®
scanner models 7874/5/6/7/8. Other models are designed for applications
with smaller footprint requirements. Additionally, a Customer Service Scanner
(CSS) module can be optionally included with a scanner for installation. The
module can be installed in various positions depending upon the checkstand
design and desired mode(s) of customer interaction. See the CSS Quick Refer
-
ence Guide (QRG) for more details.
Counter Cutout
The following guidelines for preparing an existing checkstand to accept a scan-
ner or incorporating the unit into a new checkstand design will not be accurate
for all installations. Although these guidelines will suffice for most standard
installations, the installer may need to make adjustments to accommodate
varying counter heights and thicknesses, support design, or other checkstand
limitations.
See "SECTION I. Pre-Installation Considerations" starting on page 17 for more
information about checkstand design.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
