Scanning Features Enter/Exit Programming Mode
Product Reference Guide
139
1D Inverse Read Control
This configuration item is used to toggle inverted label reading for 1D bar
codes, for example, a label printed as white on black as opposed to black on
white.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Pro-
gramming Mode bar code.
1D Inverse Read Control = Disable
1D Inverse Read Control = Enable
DEFAULT