Datalogic RIDA DBT6400 - RGB Good Read Raising Time

Reading Parameters Enter/Exit Programming Mode
Product Reference Guide 97
RGB Good Read Raising Time
Specifies the time it will take for the RGB good read to change the status from
an Off state to Brightness state.
See
"RGB Good Read Raising/Falling Time" on page 243 for more detailed program-
ming instructions.
Set RGB Good Read Raising Time
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by two digits
from the Alphanumeric characters in
Appendix D,
Keypad
representing your desired character(s). End by
scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
CANCEL
DEFAULT
00 = No time
$CRBRT
~