Datalogic RIDA DBT6400 - Enable Character

Enter/Exit Programming Mode Enable Character
32 RIDA™ DBT6400
Enable Character
Specifies the value of the RS-232 host command used to enable the scanner.
ASCII characters or any hex value from 0 to 0xFF can be selected. See "Enable
Character" on
page 232 for more detailed programming instructions
NOTE
Select Enable Character Setting
DEFAULT
0x45 = Enable Character is ‘E’
Setting to previously defined characters such as XON, XOFF, or
host commands conflicts with normal operation of these char-
acters.
.
$CR2EC