Datalogic RIDA DBT6400 - Select Audio Jingle for Enter Base Station

Reading Parameters Enter/Exit Programming Mode
Product Reference Guide 85
Select Audio Jingle for Enter Base Station
This parameter selects which preloaded Jingle to use in indicating an Enter Base
Station event.
NOTE
"Audio Jingle Enable" on page 82 must be selected for this configuration
item to take effect.
After uploading up to fifteen (15) Jingles to the scanner using the Datalogic
Aladdin
™
configuration utility, use this setting to designate which of the Jingles
(1-15) will be sounded when the scanner enters Base Station.
Select Audio Jingle on Enter Stand Mode
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by two digits
from the Alphanumeric characters in
Appendix D,
Keypad
representing the desired Jingle #. End by scan-
ning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save
the entry string. You can then start again at the
beginning.
CANCEL
DEFAULT
00 = Use built-in Enter Base Station indication
NOTE
The capability to download Audio jingle require Datalogic Aladdin™ configu-
ration software, for this reason it is possible
only if the reader is used with
the base station.
$CAUEM
~