Reading Parameters Enter/Exit Programming Mode
Product Reference Guide
87
Select Audio Jingle for Transmit Error Sound
This parameter selects which preloaded Jingle to use to indicate a Transmit
Error sound.
NOTE
"Audio Jingle Enable"
on page 82 must be selected for this configuration
item to take effect.
After uploading up to fifteen (15) Jingles to the scanner using the Datalogic
Aladdin
™
configuration utility, use this setting to designate which of the Jingles
(1-15) will be sounded when the scanner performs a good read.
Select Audio Jingle on Tx Error event
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by two digits
from the Alphanumeric characters in
Appendix D,
Keypad
representing the desired Jingle #. End by scan-
ning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save
the entry string. You can then start again at the
beginning.
CANCEL
00 = Use built-in Transmit Error Sound indication
NOTE
The capability to download Audio jingle require Datalogic Aladdin™ configu-
ration software, for this reason it is possible
only if the reader is used with
the base station.
$CAUAL
~
To Next Page
Loading...
Need help?
General
Weight and Dimensions
