Datalogic RIDA DBT6400 - Label ID Symbology Selection

Enter/Exit Programming Mode Label ID
70 RIDA™ DBT6400
Label ID Symbology Selection
This option selects the symbology for which a Label ID is to be configured. See
"Label ID: Set Individually Per Symbology" on
page 240
Set UPC-A Label ID Character(s)
Set UPC-A/P2 Label ID Character(s)
Set UPC-A/P5 Label ID Character(s)
Set UPC-E Label ID Character(s)
Set UPC-E/P2 Label ID Character(s)
Set UPC-E/P5 Label ID Character(s)
for full instructions.
$CABID
$CA2ID
$CA5ID
$CEBID
$CE2ID
$CE5ID