Datalogic RIDA DBT6400 - Programming Mode

Technical Specifications
276 RIDA™ DBT6400
Programming Mode
The following indications ONLY occur when the reader is in Programming Mode.
INDICATION DESCRIPTION LED BEEPER
Label Program-
ming Mode
Entry
A valid programming label has
been scanned.
LED blinks continuously.
Reader sounds four low fre-
quency beeps.
Label Program-
ming Mode
R
ejection of
Label
A label has been rejected. N/A
Reader sounds three times at
lowe
st frequency and current
volume.
Label Program-
ming Mode
Acceptance of
Pa
rtial Label
In cases where multiple labels
must be scanned
to program
one feature, this indication
acknowledges each portion as
it is successfully scanned.
N/A
Reader sounds one short beep
at
highest frequency and cur-
rent volume.
Label Program-
ming Mode
Acceptance of
Program
ming
Configuration option(s) have
been succes
sfully pro-
grammed via labels and the
rea
der has exited Program-
ming Mode.
N/A
Reader sounds one high fre-
quency beep and 4 low fre-
quency beeps followed by
re
set beeps.
Label Program-
ming Mode Can-
cel Item Entry
Cancel label has been scanned. N/A
Reader sounds two times at
low frequency and current vol-
ume.