Datalogic RIDA DBT6400 - Base Station Interface Selection

Setup
12 RIDA™ DBT6400
Base Station Interface Selection
Upon completing the physical connection between the base and its host, pro-
ceed directly to Interface Selection to select the kind of USB interface type the
bas
e is connected to; scan the appropriate bar code for your system’s interface
type.
The base will support the foll
owing USB host interfaces:
• USB COM to simulate RS-232 standard interface
• USB-OEM (can be used for OPOS/UPOS/JavaPOS)
• USB Keyboard
• USB Composite (KEYBOARD + COM)
For defaults and additi
onal information associated with each interface, proceed
to the corresponding chapter in the Product Reference Guide.
Configuring the Interface
Scan the programming bar code which selects the appropriate interface type for
the system the reader will be connected to.
NOTE
USB INTERFACES
USB COM to simulate RS-232 standard interface
Select USB-COM-STD
a
a. Download the correct USB COM driver from www.datalogic.com.
USB-OEM
(can be used for OPOS/UPOS/JavaPOS)
Select USB-OEM
USB Keyboard
Select USB Keyboard
USB Composite
Select USB Composite
a
Unlike some other programming features and options, interface selections
require that you scan only one programming bar code label. DO NOT scan an
ENTER/EXIT bar code prior to scanning an interface selection bar code.