Datalogic RIDA DBT6400 User Manual

Customizing Configuration Settings
Product Reference Guide 15
Resetting the Product Configuration to Defaults
If you aren't sure what programming options are in your scanner, or you've
changed some options and want to restore the Custom Default Configuration
that may have been saved in the scanner, scan the
Restore Custom Default Config-
uration
bar code below. This will restore the custom configuration for the cur-
rently active interface.
NOTE
$P,HA00,P
Restore Custom Default Configuration
Custom defaults are based on the interface type. Configure the scanner for
the correct interface before scanning this label.
If you aren't sure what programming options are in your scanner, or you've
changed some options and want to restore the Factory Configuration, you have
two options. You can scan the
Restore USA Factory Configuration bar code or the
Restore EU Factory Configuration bar code below. Both labels restore the scanner
configuration to the factory settings including the interface type. The USA label
re
stores Label IDs to those historically used in the USA. The EU label restores
Label IDs to those historically used in Europe. The Label ID sets for USA and EU
are shown in the Label ID section of this manual.
CAUTION
Restore USA Factory Configuration
$P,AE,P
Restore EU Factory Configuration
$P,Ae,P
Scanning either of the “Restore Factory Configuration” commands below
will result in the loss of any custom configuration settings for your device.
The programming section on the following pages lists the factory default set-
tings for each of the menu commands (indicated by shaded blocks and bold
te
xt).

Datalogic RIDA DBT6400 Specifications

General

Scanner type	Handheld scanner
Type	Handheld bar code reader
Wavelength	650 nm
Sensor type	-
Yaw reading angle	-60 - 60 °
Tilt reading angle	0 - 360 °
Pitch reading angle	-65 - 65 °
Linear (1D) barcodes supported	JAN, PostBar, RM4SCC / KIX
2D (matrix & stacked) barcodes supported	Aztec Code, Composite Codes, Data Matrix, GS1 DataBar Expanded Stacked, GS1 DataBar Stacked Omnidirectional, Han Xin, MaxiCode, Micro QR Code, MicroPDF417, QR Code
Wireless range	25 m
Bluetooth version	4.0
Operating frequency	2400 MHz
Standard interfaces	Bluetooth, USB
Connectivity technology	Wired & Wireless
Battery life	5 h
Charging time	2.5 h
Battery capacity	700 mAh
Power source type	Battery
Number of reads per charge	3000
Number of batteries supported	1
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	0 - 50 °C
Operating relative humidity (H-H)	5 - 95 %
Product color	White
International Protection (IP) code	IP50
Sustainability certificates	RoHS
Cables included	No
Harmonized System (HS) code	84716070

Weight and Dimensions

Depth	42.3 mm
Width	112.5 mm
Height	27.5 mm
Weight	85 g