Setup
8 RIDA™ DBT6400
Replacing the Battery Pack
NOTE
Before proceeding, read “Battery Safety” in the Safety and Regulatory Adden-
dum. Datalogic recommends annual replace
ment of rechargeable battery packs
to ensure maximum performance.
1. Use a T5 type screwdriver to unscrew the cover of the battery pack until it
is disengaged.
2. Pull up the battery pack and disconnect the cable from the battery connec-
tor. For this operation you can use a plastic nipper. If under the battery
th
ere is any label that covers the battery connector, remove it.
To mount the new battery pack reverse the process. Restore the label under the
battery if it was present. Use the new one included in battery spare part.
To Next Page
Loading...
