Datalogic RIDA DBT6400 - BT PIN Code; Select PIN Code Length; Set PIN Code

Enter/Exit Programming Mode
264 RIDA™ DBT6400
BT PIN Code
After enabling Security Mode (see "BT Security Level" on page 262), specify whether
you want to set a 4-digit or a 16-digit PIN Code.
$CBTPS00\r
Select 4-character BT PIN Code
DEFAULT
~$CBTPS01\r
Select 16-character BT PIN Code
Select PIN Code Length
Set PIN Code
Determine the desired characters for the PIN code, then convert to hexadecimal using
the ASCII Chart on the inside back cove
r of this manual.
$CBTPC
Set 4-character BT PIN Code
To configure this feature, scan the ENTER/EXIT PROGRAM-
MING MODE bar code above, then the bar code at left fol-
lowed by the digits from the Alphanumeric characters in
Appendix D, Keypad representing your desired charac-
ter(s). End by scanning the ENTER/
EXIT bar code again.
$CBTP6
Set 16-character BT PIN Code
~
CANCEL
Make a mistake? Scan the CANCEL bar code to abort and
not save
the entry string. You can then start again at the
beginning.
31323334 = Default PIN Code is 1234
DEFAULT