Datalogic RIDA DBT6400 - Micro Qr Code Set Length 1

Enter/Exit Programming Mode Micro QR Code
218 RIDA™ DBT6400
Micro QR Code Set Length 1
Specifies one of the bar code lengths for Micro QR Code Length Control on page
217. Length 1 is the minimum label length if in Variable Lengt
h Mode, or the
first fixed length if in Fixed Length Mode. Characters can be set from 0001 to
0
035 characters in increments of 0001 (pad with zeroes).
See page 248 for detailed instructions on setting this feature.
$CMQL1
Select Micro QR Code Length 1 Setting
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left followe
d by the digits from the Alphanumeric char-
acters in
Appendix D, Keypad representing your
desired character(s). End by scanning the ENTER/E
XIT
bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save
the entry string. You can then start again at the
beginning.
~
CANCEL
DEFAULT
0001 = Length 1 is 1 Character