Reading Parameters Enter/Exit Programming Mode
Product Reference Guide
103
Scanning Active Time
This setting specifies the amount of time that the reader stays in scan ON state
once the state is entered. The range for this setting is from 1 to 255 seconds in
1-second increments. See
"Scanning Active Time"
on page 246 for more detailed
programming instructions.
Select Scanning Active Time Setting
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
Appendix D, Keypad
representing your desired character(s). End by scanning
the EN
TER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save
the entry string. You can then start again at the
beginning.
CANCEL
DEFAULT
005 = Scanning is active for 5 Seconds
Pick Mode
Specifies the ability of the reader to decode labels only when they are close to
the center of the aiming pattern. This allows the reader to accurately target
labels when they are placed close together, such as on a pick sheet.
NOTE
This feature is not compatible with Multiple Labels Reading in a Volume.
Pick Mode = Disable
Pick Mode = Enable
$CSNET
~
To Next Page
Loading...
Need help?
General
Weight and Dimensions
