Datalogic RIDA DBT6400 - Aztec Code; Aztec Code Enable; Disable; Aztec Code Length Control

Enter/Exit Programming Mode Aztec Code
196 RIDA™ DBT6400
Aztec Code
Aztec Code Enable / Disable
Enables/disables the ability of the reader to decode Aztec Code labels.
DEFAULT
$CAZEN00(CR)
Aztec Code = Disable
$CAZEN01(CR)
Aztec Code = Enable
Aztec Code Length Control
This feature specifies either variable length decoding or fixed length decoding
for this symbology.
Variable Length: For variable length decoding, a minimum and maximum length
may be set.
Fixed Length: For fixed length decoding, two different lengths may be set.
DEFAULT
$CAZLC00(CR)
Aztec Code Length Control = Variable Length
$CAZLC01(CR)
Aztec Code Length Control = Fixed Length
Aztec Code Set Length 1
Specifies one of the bar code lengths for Aztec Code Length Control on page
196. Length 1 is the minimum label length if in Variable Lengt
h Mode, or the
first fixed length if in Fixed Length Mode. Characters can be set from 0001 to
3,
832 characters in increments of 0001 (pad with zeroes).