Setup
14 RIDA™ DBT6400
Interface Settings
The scanner and the base station (if available) are typically factory-configured
with a set of default features standard to the interface type you ordered. See
"Base Station Interface Selection"
on page 12.
Global Interface Features, starting on page 21
provides settings configurable by all
base station interface types. If your installation requires you to further custom-
ize your scanner, you can select other options through use of the instructions
and prog
ramming bar codes available in the appropriate section for your inter-
face.
•
USB-COM Interfaces, starting on page 23
•
Keyboard Interface, starting on page 33
•
USB-OEM Interface, starting on page 63
Configuring Other Features
If your installation requires different programming than the standard factory
default settings, the following sections of this manual allow configuration of
non-interface-specific settings you might require:
Configuration Using Bar Codes
:
General Features includes programming for scan-
ning, speaker and LED indicators and other such universal settings.
Reading Parameters
:
Reading Parameters include programming for scanning,
speaker and LED indicators and other universal settings.
1D Symbologies
:
Includes options concerning the bar code label types (symbolo-
gies). These settings allow you to enable/disable symbologies, set label
le
ngths, require check digit, etc.
Software Version Transmission
The software version of the device can be transmitted over the wireless BT
Scanner Profile interfaces or the USB Base Station interfaces by scanning the
following label.
Transmit Software Version
RevA
To Next Page
Loading...
Need help?
General
Weight and Dimensions
