Datalogic RIDA DBT6400 - Global Prefix;Suffix

Enter/Exit Programming Mode Global Prefix/Suffix
66 RIDA™ DBT6400
Global Prefix/Suffix
Up to 20 ASCII characters may be added as a prefix (in a position before the bar
code data) and/or as a suffix (in a position following the bar code data). See
"Global Prefix/Suffix" on
page 236 for more detailed programming instructions.
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from the
Alphanumeric characters in
Appendix D, Keypad repre-
senting your desired character(s). End by scanning the
ENTER/EXIT
bar code again.
Set Global Prefix
Set Global Suffix
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from the
Alphanumeric characters in
Appendix D, Keypad rep-
resenting your desired character
(s). End by scanning the
ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
CANCEL
DEFAULT
No Global Prefix
Global Suffix = 0x0D(CR)
$CLFPR
$CLFSU
~