Datalogic RIDA DBT6400 - RGB Auto Delay

Enter/Exit Programming Mode RGB LED Settings
100 RIDA™ DBT6400
RGB Auto Delay
Specifies the delay time for running the RGB auto mode after the scanner has
gone into an idle state (no label reading, label programming or communication
with Host). The value 0x00 means Auto Mode is disabled. See
"RGB Auto Delay
Time"
on page 245 for more information.
Set RGB Auto Delay
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
Appendix D, Keypad
representing your desired character(s). End by scanning
the ENTER/EXIT bar code agai
n.
Make a mistake? Scan the CANCEL bar code to abort and
not save
the entry string. You can then start again at the
beginning.
CANCEL
DEFAULT
04 = 2 seconds Auto Delay
$CRBID
~