USB-COM Interfaces Enter/Exit Programming Mode
Product Reference Guide
23
USB-COM Interfaces
The programming bar codes in this chapter allow modifications to the standard
RS-232 / USB-Com interfaces.
STANDARD FACTORY SETTINGS on page 23
INTERCHARACTER DELAY on page 24
BEEP ON ASCII BEL on page 25
BEEP ON NOT ON FILE on page 25
ACK NAK OPTIONS on page 26
ACK CHARACTER on page 27
NAK CHARACTER on page 27
ACK NAK TIMEOUT VALUE on page 28
ACK NAK RETRY COUNT on page 29
ACK NAK ERROR HANDLING on page 30
INDICATE TRANSMISSION FAILURE on page 31
DISABLE CHARACTER on page 31
ENABLE CHARACTER on page 32
Standard Factory Settings
Reference Appendix B, for a listing of standard factory settings.
To Next Page
Loading...
