Datalogic RIDA DBT6400 - Beep on ASCII BEL; Beep on Not on File

USB-COM Interfaces Enter/Exit Programming Mode
Product Reference Guide 25
Beep On ASCII BEL
When this parameter is enabled, the scanner issues a beep when a <BEL> char-
acter is detected on the RS-232 serial l
ine. <BEL> is issued to gain a user's
attention to an illegal entry or other important event.
Beep On ASCII BEL = Disable
DEFAULT
Beep On ASCII BEL = Enable
Beep On Not on File
This option enables/disables the action of the scanner to sound a three beep
sequence upon receiving a Not-On-File (NOF) host command.
Beep On Not On File = Disable
DEFAULT
Beep On Not On File = Enable
$CR2BB00
$CR2BB01
$CBPNF00
$CBPNF01