Enter/Exit Programming Mode Code 93
186 RIDA™ DBT6400
Code 93 Set Length 2
This feature specifies one of the bar code lengths for Code 93 Length Control
on page 184. Length 2 is the maximum label length if in Variable Length on
page 184 Mode, or the second fixed length if in Fixed Length on
page 184
Mode. Length includes the bar code’s chec
k, data, and full-ASCII shift charac-
ters. The length does not include start/stop characters.
The length can be set from 1 to 50 characters. A setting of 00 specifies to
ig
nore this length (only one fixed length). See "Set Length 2" on
page 250 for
more detailed programming instructions.
Select Code 93 Length 2 Setting
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
Appendix D, Key-
pad
representing your desired character(s). End by
scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
CANCEL
DEFAULT
50 = Length 2 is 50 Characters
$CC9L2
~
To Next Page
Loading...
Need help?
General
Weight and Dimensions
