Datalogic RIDA DBT6400 - Qr Code Set Length 2

Enter/Exit Programming Mode QR Code
216 RIDA™ DBT6400
QR Code Set Length 2
This feature specifies one of the bar code lengths for QR Code Length Control
on page 214. Length 2 is the maximum label length if in Variable Length Mode,
or the second fixed length if in Fixed Len
gth Mode. Characters can be set from
0001 to 7,089 characters in increments of 0001 (pad with zeroes).
See page 250 for detailed instructions on setting this feature.
$CQRL2
Select QR Code Length 2 Setting
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left followe
d by the digits from the Alphanumeric char-
acters in
Appendix D, Keypad representing your
desired character(s). End by scanning the ENTER/E
XIT
bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save
the entry string. You can then start again at the
beginning.
~
CANCEL
DEFAULT
Length 2 is 7,089 Characters