Datalogic RIDA DBT6400 - RGB Good Read Holding Time

Reading Parameters Enter/Exit Programming Mode
Product Reference Guide 99
RGB Good Read Holding Time
Specifies how long the RGB good read will stay in Brightness state. See "RGB
Good Read Holding Time"
on page 244 for more information.
Set RGB Good Read Holding Time
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
Appendix D, Keypad
representing your desired character(s). End by scanning
the EN
TER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save
the entry string. You can then start again at the
beginning.
CANCEL
DEFAULT
14 = 2 seconds Holding Time
$CRBHT
~