Datalogic RIDA DBT6400 - ACK Character; NAK Character

USB-COM Interfaces Enter/Exit Programming Mode
Product Reference Guide 27
ACK Character
This setting specifies an ASCII character or hex value to be used as the ACK
character. ASCII characters or any hex value from 0 to 0xFF can be selected. See
"ACK Character" on
page 227 for more detailed programming instructions.
NOTE
Select ACK Character Setting
DEFAULT
0x06 ‘ACK’ Character
Setting to previously defined characters such as XON, XOFF, or
host commands conflicts with normal operation of these char-
acters.
NAK Character
This setting specifies an ASCII character or hex value to be used as the NAK
character. ASCII characters or any hex value from 0 to 0xFF can be selected. See
"NAK Character" on
page 227 for more detailed programming instructions.
NOTE
Select NAK Character Setting
DEFAULT
0x15 ‘NAK’ Character
Setting to previously defined characters such as XON, XOFF, or
host commands conflicts with normal operation of these char-
acters.
$CR2AC
$CR2NA