1D Symbologies Enter/Exit Programming Mode
Product Reference Guide
131
Code 39 Set Length 1
This feature specifies one of the bar code lengths for Code 39 Length Control
on page 130. Length 1 is the minimum label length if in Variable Length on
page 130 Mode, or the first fixed length if in Fixed Length on page 130 Mode.
Length includes the bar code’s check, data, an
d full-ASCII shift characters. The
length does not include start/stop characters.
The length can be set from 0 to 50 characters. See "Set Length 1" on page 248
for more detailed programming instructions.
Select Code 39 Set Length 1 Setting
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
Appendix D, Key-
pad
representing your desired character(s). End by
scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
CANCEL
DEFAULT
02 = Length 1 is 2 Characters
$CC3L1
~
To Next Page
Loading...
