Datalogic RIDA DBT6400 - Rf Address Stamping; Source Radio Address Transmission; Source Radio Address Delimiter Character

Wireless Features Enter/Exit Programming Mode
Product Reference Guide 261
RF ADDRESS STAMPING
These features allow configuration of source radio data inclusion.
Source Radio Address Transmission
Enables/disables the ability of source radio address information to be transmitted to
the host and, if so, at what position with respect to the label data.
DEFAULT
$CBTAS00(CR)
Source Radio Address Transmission = Do Not Include
$CBTAS01(CR)
Source Radio Address Transmission = Prefix
When included as a prefix, the source-radio ID is displayed after all
label formatting has been applied. The 6 byte hex address is sent as
12 ascii characters, i.e., an address of 00 06 66 00 1A ED will be sent as
(shown in hex): 30 30 30 36 36 36 30 30 31 41 45 44
Source Radio Address Delimiter Character
This option specifies the delimiter character to be placed between the label data and
radio address when address stamping is enabled.
This feature only applies if "Source Radio Address Transmis-
sion"
on page 261 is enabled.