Enter/Exit Programming Mode
20 RIDA™ DBT6400
To program features:
1. Scan the ENTER/EXIT PROGRAMMING bar code, available at the top of each
programming page, when applicable.
2. Scan the bar code to set the desire
d programming feature. You may need
to cover unused bar codes on the page, and possibly the facing page, to
ensure that the scanner reads only the bar code you intend to scan.
3. If additional input parameters ar
e needed, go to
Appendix D, Keypad
, and
scan the appropriate characters from the keypad.
NOTE
Additional information about many features can be found in the “Ref-
erences” chapter.
If you make a mistake before the last character, scan the CANCEL bar
code to ab
ort and not save the entry string. You can then start again at
the beginning.
4. Complete the programming sequence by scanning the ENTER/EXIT PRO-
GRAMMING bar code to ex
it Programming Mode.
For more detailed descriptions, programming information an
d examples for
setting selected configuration items, see
References, starting on page 235
.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
