5 Applied Instructions and Basic Usage
DVP-20PM Application Manual
5-238
Checking the length of a cutting: The length of a cutting is 1320 mm. Convert the length of a
cutting into the number of pulses which the master axis sends in a cycle. (A motor unit is used.
1320/188x100000=702127.) Check whether the length of the cam curve in the cam chart
uploaded is 702127 pulses. If the length of the cam curve in the cam chart uploaded is 702127
ction block T_FlyingSaw are set correctly. pulses, the parameters in the motion control fun
4. Troubleshooting
Error Troubleshooting
The values of input pins in the motion control function Check whether the values o
block are incorrect. ranges allowed.
f the input pins are in the
A cam curve can not be created.
Check whether the values of the parameters in the
motion control block can be used to create a cam
curve.
5. Modules which are supported
The motion control function block T_FlyingSaw supports DVP20PM00D and DVP20PM00M.
To Next Page
Loading...
