TEST ACTION APPLICABILITY
1 With the DRBIIIt, attempt to communicate with the ABS, ACM, EATX, SBEC, or
SKIM module.
Was the DRBIIIt able to I/D or communicate with the Module in question?
All
Yes → Go To 2
No → Refer to Communication category for the related symptom(s).
2 With the DRBIIIt, erase DTCs.
Cycle the ignition, wait approximately 1 minute.
With the DRBIIIt, read DTCs.
Did the DTC reset?
All
Yes → Replace the Instrument Cluster in accordance with the Service
Information.
Perform BODY VERIFICATION TEST - VER 1.
No → The condition is not present at this time. Monitor DRBIIIt
parameters while wiggling the related wire harness. Refer to any
Technical Service Buletins (TSB) that may apply. Visually inspect
the related wiring harness and connector terminals.
141
INSTRUMENT CLUSTER
ABS MESSAGE NOT RECEIVED — Continued
To Next Page
Loading...
