EasyManua.ls Logo

Dodge 2004 Neon SRT4 - Doors Lockable with Key in Ignition & Driver Door Open

Dodge 2004 Neon SRT4
922 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Symptom:
*DOORS LOCKABLE WITH KEY IN IGNITION & DRIVER DOOR
OPEN
POSSIBLE CAUSES
DRIVER DOOR AJAR SWITCH - OPEN
OPEN DRIVER DOOR AJAR SWITCH SENSE TO RKE MODULE
IGNITION SWITCH OPEN
KEY-IN IGNITION SWITCH SENSE WIRE OPEN
OPEN DRIVER DOOR AJAR SWITCH SENSE TO CLUSTER
INSTRUMENT CLUSTER - KEY-IN IGNITION OPEN
INSTRUMENT CLUSTER DEFECTIVE-DRIVER DOOR AJAR OPEN
RKE MODULE DEFECTIVE-OPEN DRIVER DOOR AJAR
TEST ACTION APPLICABILITY
1 Open the Drivers door.
With the DRB III select: 9Body99Electro/Mech Cluster99Input/Output9
Read the 9Drv Door Ajar Sw9 state.
Does the DRBIII Show: 9CLOSED9?
All
No Go To 2
Yes Go To 5
2 Remove the driver door inner trim panel to gain access to the Door Lock Motor/Ajar
Switch connector.
Disconnect the Door Lock Motor/ Ajar Switch connector (Left Front or Right Front).
Connect a jumper wire between Door Ajar Switch Sense circuit (driver door) and
ground.
With the DRB III select: 9Body99Electro/Mech Cluster99Input/Output9
Read the 9Drv Door Ajar Sw9 state.
Does the DRBIII show: 9Closed9?
All
Yes Replace the Driver Door Ajar Switch.
Perform BODY VERIFICATION TEST - VER 1.
No Go To 3
3 Turn ignition off.
Disconnect the Door Lock Motor/Ajar Switch (driver door) connector.
Disconnect the Instrument Cluster connector.
Measure the resistance of the Door Ajar Switch Sense (driver door) circuit between
the Door Lock Motor/Ajar Switch connector and the Instrument Cluster connector.
Is the resistance below 5.0 ohms?
All
Yes Go To 4
No Repair the Driver Door Ajar Switch Sense wire for an open.
Perform BODY VERIFICATION TEST - VER 1.
204
POWER DOOR LOCKS/RKE

Table of Contents

Other manuals for Dodge 2004 Neon SRT4

Related product manuals