Symptom:
P1793-TRD LINK COMMUNICATION ERROR
When Monitored and Set Condition:
P1793-TRD LINK COMMUNICATION ERROR
When Monitored: The Transmission Control Module (TCM) pulses the 12 volt TRD signal
from the Powertrain Control Module (PCM) to ground, during torque managed shifts with
the throttle angle above 54 degrees. The TRD system is also tested whenever the vehicle
is stopped and the engine speed is at idle.
Set Condition: This DTC is set when the Transmission Control Module (TCM) sends two
subsequent torque reduction messages to the Powertrain Control Module (PCM) and does
not receive a confirmation from the PCM. Note: Due to the integration of the Powertrain
and Transmission Control Modules, bus communication between the modules is internal.
POSSIBLE CAUSES
POWERTRAIN CONTROL MODULE
TEST ACTION APPLICABILITY
1 NOTE: Due to the integration of the Engine and Transmission controllers
into one module, the TRD bus messages are sent over a internal bus circuit.
View repair.
All
Repair
Replace the Powertrain Control Module per the Service Informa-
tion. WITH THE DRBIIIt PERFORM QUICK LEARN AND
REPROGRAM PINION FACTOR.
Perform 41TE (NGC) TRANSMISSION VERIFICATION TEST -
VER 1.
163
TRANSMISSION - NGC
To Next Page
Loading...
