Symptom:
MODULE NOT CONFIGURED FOR SAB
When Monitored and Set Condition:
MODULE NOT CONFIGURED FOR SAB
When Monitored: With ignition on, the ACM monitors the PCI Bus for a message
containing an 9A9 in the 4 th position of the VIN. This character identifies the type of safety
equipment and should match the VIN. The PCM transmits the VIN every 13.76 seconds.
Set Condition: The code will set, if the ACM detects a Side Impact Airbag Module active
on the PCI Bus and the 4 th character of the VIN message is not an 9A9.
POSSIBLE CAUSES
CHECK PCM VIN
PCM, PCI COMMUNICATION FAILURE
MODULE NOT CONFIGURED
ACM, NOT CONFIGURED FOR SIDE AIRBAGS
STORED CODE OR INTERMITTENT CONDITION
ACTIVE CODE PRESENT
TEST ACTION APPLICABILITY
1 Turn the ignition on.
Ensure the battery is fully charged.
NOTE: For the purpose of this test, the AECM and ORC modules will be
referred to as an ACM.
SELECT ACTIVE or STORED DTC:
All
ACM - ACTIVE DTC
Go To 2
ACM - STORED DTC
Go To 6
NOTE: When reconnecting Airbag system components, the ignition must be
turned off and the battery must be disconnected.
2 Turn the ignition on.
Connect the DRB to the data link connector and select PCM, SYSTEM TEST.
Does the DRB show PCM Active on the Bus:?
All
Yes → Go To 3
No → Refer to category COMMUNICATION and select the related
symptom.
Perform AIRBAG VERIFICATION TEST - VER 1.
47
AIRBAG
To Next Page
Loading...
Need help?
General
