Symptom:
*PARK LAMPS FAIL TO FLASH DURING ALARM
POSSIBLE CAUSES
PARK LAMP SWITCH OUTPUT CIRCUIT OPEN
REMOTE KEYLESS ENTRY MODULE
TEST ACTION APPLICABILITY
1 Ensure the park lamps are operational from the multifunction switch. If the park
lamps are inoperative, refer to the appropriate Service Information and repair the
Park Lamp circuit as necessary.
Disconnect the Remote Keyless Entry Module connector.
Connect a test light to the Park Lamp Switch Output circuit (cav 2) to ground.
Turn the Park Lamps on.
Does the test light illuminate when the Park Lamps are on?
All
Yes → Replace the Remote Keyless Entry Module.
Perform VTSS VERIFICATION TEST - 1A.
No → Repair the Park Lamp Switch Output circuit for an open.
Perform VTSS VERIFICATION TEST - 1A.
227
VEHICLE THEFT/SECURITY